Sunbeam Rapier Owners Club
Sunbeam Rapier Owners Club
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 Technical
 Help!
 H120 clutch slave cylinder replacement
 New Topic  Reply to Topic
 Printer Friendly
New posts at top
New posts at bottom
Author Previous Topic Topic Next Topic  

puffin

United Kingdom
15 Posts

Posted - 14 Oct 2021 :  13:10:55  Show Profile  Reply with Quote
Hi there,
Just moved house and can't find my workshop manual- Need to replace the clutch slave cylinder and wondered if there are any obvious snags- replacement sent by speedy spares is approx 3" overall in length with 2 horizontal screw fittings at rear, assume top for bleed nipple and bottom for pipe from master. All advice gratefully received!
David

IanEndurer

United Kingdom
35 Posts

Posted - 23 Oct 2021 :  14:03:36  Show Profile  Reply with Quote
Hi David,

Yes that's correct the bottom is to master and top is bleed nipple. Fairly straightforward to fit- remove rod from clutch arm(held on by split pin) then undo master feed then remove 2 fixing bolts- assembly is reversal of removing. Simply bleed system a d enjoy light clutch feel!
Good luck.
Ian.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
New posts at top
New posts at bottom
Jump To:
Sunbeam Rapier Owners Club © 2009 Sunbeam Rapier Owners Club Go To Top Of Page
Snitz Forums 2000